How to Plan a DIY Fence Project in Maryland: A 5-Step Guide

atlantic fence & supply, how to plan a diy fence project in maryland: a 5-step guide

DIY fence installation is a big project, but it’s very doable with a good plan. Most of the mistakes we see at the counter happen before the first post goes in the ground: the wrong style, a missing gate, or a supply list that comes up short.

This guide walks you through planning a DIY fence installation in five steps. When you’re done, bring your list to our Hanover yard and we’ll help you check it.

Step 1: Choose your fence style

Start with why you want a fence. Privacy, pets, kids, a pool, or just curb appeal? Each goal points to a different style.

  • Chain link: affordable, strong and easy to maintain. Great for pets and large yards.
  • Wood: classic look and full privacy. Styles include picket, board-on-board and shadow box.
  • Vinyl / PVC: low maintenance. No painting or staining, just soap and water.
  • Ornamental: steel or aluminum. A popular choice around pools.
  • Split rail: rustic and simple. Good for marking property lines and farms.

Step 2: Check the rules before you dig

A few phone calls now can save you from tearing out a finished fence later.

  • Know your property line. Your property survey or plat shows where your land ends.
  • Check with your county and HOA. Many have rules about fence height, style and permits.
  • Call Miss Utility before you dig. Dial 811 or visit missutility.net to have underground lines marked. It’s free, and in Maryland it’s required.

Step 3: Measure your space

Walk the line where your fence will go and measure each side in feet. Then add the sides together for your total length.

homeowner measuring a backyard with stakes and string to plan a diy fence installation

Write down:

  • The length of each side
  • Every corner and end point (each one needs a post)
  • Any slopes, trees or obstacles along the line

A simple sketch on paper is all you need. Bring it with you, and we’ll use it to figure out your materials.

Step 4: Decide where your gates go

Gates are easy to forget and hard to add later. Think about how you’ll use your yard:

  • Will you need to get a mower, wheelbarrow or trash cans through?
  • Do you want a walk gate, a double drive gate, or both?
  • Which way should the gate swing?

Mark each gate on your sketch with its width.

Step 5: Build your supply list and visit us

With your style, measurements and gates figured out, you’re ready to build the supply list for your DIY fence installation:

  • Posts (line posts, corner posts and end posts)
  • Panels, pickets, boards or chain link fabric
  • Rails
  • Gates and gate hardware (hinges, latches)
  • Fasteners and fittings
  • Concrete or gravel for setting posts

Not sure what you need? Bring your sketch to Atlantic Fence & Supply in Hanover, MD, or call us at 410-796-4747. We’ll build your material list with you and make sure nothing is missing.

Common DIY Fence Installation to Avoid

We’ve helped a lot of homeowners at our counter, and the same few mistakes come up again and again:

  • Skipping the Miss Utility call. Hitting a buried gas or electric line is dangerous and expensive.
  • Buying materials before checking HOA rules. Some neighborhoods limit fence height, style or color.
  • Forgetting the gate. Adding one after the fence is up means extra work and extra parts.
  • Ignoring slopes. A yard that isn’t flat may need a different panel style or extra posts.
  • Coming up short on hardware. It’s easy to count panels and forget hinges, latches and fittings.

A little planning saves you a second trip and a lot of frustration.

Rather have someone else install it?

No problem, DIY fence installation isn’t for everyone, and that’s okay. Visit our residential fence installation page and we’ll connect you with a trusted installer in your area.

Leave a Reply

Your email address will not be published. Required fields are marked *